PDA

View Full Version : some problem with RailSweep

Johny_Cage
12-11-2008, 11:24 PM
Hi,

I have some problem with RailSweep, attached picture say more, thanx for your time.
PiXeL_MoNKeY
12-12-2008, 11:54 AM
Can you post the file? Would be easier to diagnose than from the image.

-Eric
Johny_Cage
12-13-2008, 12:16 AM
Can you post the file? Would be easier to diagnose than from the image. 2rail1edge

-Eric

ok, posted.
PiXeL_MoNKeY
12-13-2008, 02:30 PM
Ok here is how to fix it:
1) Remove all the sketches and delete the Rail Sweep.
2) Make a new Rail Sweep (this time 2 shapes and 1 rail).
3) Select what were the Rails as the Shapes, and the back as the Rail.
4) Enable Rotational (under Uniform Scaling of Shapes).

Done,
-Eric
JohnyCageII
06-10-2009, 03:47 AM
I have a new problem with RS. The problem is described in atached picture :confused: . Thanx for your time.
JohnyCageII
06-10-2009, 06:18 AM
The second question..I am working on the top part of car. I solve this part such as you can see on the pic1.jpg and pic2.jpg. It is 3x rail sweep tool and 1x trim tool. I dlike to have 1x railsweep tool and 3x trimtool. Is it possible ? I tested it but the result was bad (pic3. Can we recognize any optimal way to realizing this task ? I atached too sourcefile (max09) for better look.


Thanx for your time.