po147ro
10-15-2009, 08:24 AM
Hi guys,
I have this problem: when I try creating clones of an edge (bezier z-key curve type with c1 bezier type vertices) within a single sketch, the new edge doesn't have "c1 bezier" type vertices but "smooth" vertices and crosses as you can see in the picture appear. If I rechange vertices in "c1 bezier" than the geometry's curve is seriously changed. I've found this problem doing the sofa tutorial on npower portal. Is a bug or simply I'm doing something wrong?
Tnaks for the help
Bye
ps: I use 3ds max design 2009 with power nurbs 6.1
I have this problem: when I try creating clones of an edge (bezier z-key curve type with c1 bezier type vertices) within a single sketch, the new edge doesn't have "c1 bezier" type vertices but "smooth" vertices and crosses as you can see in the picture appear. If I rechange vertices in "c1 bezier" than the geometry's curve is seriously changed. I've found this problem doing the sofa tutorial on npower portal. Is a bug or simply I'm doing something wrong?
Tnaks for the help
Bye
ps: I use 3ds max design 2009 with power nurbs 6.1