splitting profile line

[ern]

Hi,

I trying to split a line several places, but I can only get the split operation to work one time, what am I doing wrong

And another thing, can a split be removed?

Regards

ern

[npower]

Ern,

you should be able to spit the sketch. Here is an vid that shows Sketch Splitting in action. If your still problems please upload the spline as a zip file and I will look into your problem.

http://www.screencast.com/t/PRGadPkX

[PiXeL_MoNKeY]

And another thing, can a split be removed?You would have to use the Join command to remove the split.

-Eric

[eric pinkel]

No, just delete it on the spline :)

[PiXeL_MoNKeY]

I have had times where it didn't work, I think. However, that was typically on converted Compound Sketch objects. I guess in those cases it really isn't a split done through the edge command. That does make it kind of confusing since they look the same.

-Eric